Troubleshooting • Re: Reading Change Logs stalls at 33%?

Hi,

I am kind of a noob in all these stuff, i just bought pi zero 2 w and configured ssh and vnc, but i am having the same problem. Someone said above in the thread that setting swap at 200 fixed it. Can anyone please tell me the command or how to increase the swap to fix the issue, the error i am getting is in installing a specific package i tried installing it seperately and it did not fix it, also if i run pi on vnc i think because of no update i am stuck in setup loop, it shows in vnc that setup your pi, i put in all the settings and then press on reboot. It takes me back at putting settings after reboot. Anybody please provide some info to how to fix it, thanks.

Statistics: Posted by ejolson — Sun May 19, 2024 8:23 pm