Thanks for your reply, I attached a picture of the diagnostics screen.remove any change made to config.txt. All of the above will be ignored by KMS graphics driver anyhow...Any suggestions?Code:
hdmi_group=2hdmi_mode=82hdmi_force_hotplug=1hdmi_drive=2config_hdmi_boost=7
Remove the uSD from the Pi. Power it up and post a picture of the boot diagnostics screen.
If nothing gets shown on the display when powering up without uSD swap to a better cable.
I was able to see this screen on both the TV and monitor.
I flashed the SD card again but still have the same result, black screen only on the monitor.
Statistics: Posted by indubitably — Fri May 24, 2024 7:43 pm