Which power supply you are using and are you create image file in Rpi imager or any other ?Hii all,
For my project i try to use Rpi Zero WH (V1.1 2017) , But i am not able to install the OS in the Rpi .
I am using sandisk -extreme Pro - SDXC -64gb micro SD card.
Powering up with my laptop USB port .
Samsung monitor with HDMI .
Till now i tried all the different version of Raspbian and old version of Jessie , NOOBS.
Nothing worked for me , when i start inserting the sd card and powering up , then the booting started since the ACT led flickering but its continuously showing some booing text and running again and again.
I tried with anothe RPi zero WH board , same problem is showing .
only i could able to install Jessie 2015-11-21 this OS , but it is not working properly .
i am using pi imager V1.8.5
SD card formatter for formatting .
Can any one help me to install the OS
I have an RPi Zero W board.
It is reliably running the current 32-bit RasPiOS Bookworm Lite OS.
My suggestions are:
Try that same OS. You won't be able to make effective use of the Desktop GUI on a device with only 512MB of RAM, so in the first place try the Lite variant, and be sure it is the 32-bit version.
Try a different microSD card.
Try a different 5 volt usb power supply.
Raspberry Pi Getting Started documentation on installing an OS via Imager here -
Install an operating system - https://www.raspberrypi.com/documentati ... ing-system
Statistics: Posted by bibhu — Thu Jul 04, 2024 5:34 am