MicroPython • Re: Pico & Micropython - .value(x) doesn't seem to work

I don't think you need PULL_* if it's an output.

Well, what do you know? Thank you.

I've taken the 'PULL_UP' out of the pin definition, and I can see the change in state on my 'scope.

I've got the output driving the base of a 2N4124 which I simply want to run as a switch to drive this 3V relay

Hongfa HFD3/003 PCB Signal Relay 3V DC Coil DPDT 2A

Unless I can drive it directly from the GPIO pin.

Statistics: Posted by APL2 — Wed Aug 21, 2024 5:05 pm

---