Hi. Thank you for your help.
Even after restarting it still doesn't find wlan0.
How do I know if my OS includes raspi-config?
Can you tell us what this is supposed to do?Code:
auto wlan0iface wlan0 inet manualwpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
If you can’t, remove it, restart and see if wlan0 is found this time.
Also, the interface can be disabled in firmware. Check with raspi-config if your OS includes that or in config.txt
Code:
pi@raspberrypi:~ $ auto wlan0bash: auto: command not foundpi@raspberrypi:~ $ iface wlan0 inet manualbash: iface: command not foundpi@raspberrypi:~ $ wpa-conf /etc/wpa_supplicant/wpa_supplicant.confbash: wpa-conf: command not foundCode:
pi@raspberrypi:~ $ cat /boot/config.txt# For more options and information see# http://rpf.io/configtxt# Some settings may impact device functionality. See link above for details# uncomment if you get no picture on HDMI for a default "safe" mode#hdmi_safe=1# uncomment this if your display has a black border of unused pixels visible# and your display can output without overscan#disable_overscan=1# uncomment the following to adjust overscan. Use positive numbers if console# goes off screen, and negative if there is too much border#overscan_left=16#overscan_right=16#overscan_top=16#overscan_bottom=16# uncomment to force a console size. By default it will be display's size minus# overscan.#framebuffer_width=1280#framebuffer_height=720# uncomment if hdmi display is not detected and composite is being output#hdmi_force_hotplug=1# uncomment to force a specific HDMI mode (this will force VGA)#hdmi_group=1#hdmi_mode=31# uncomment to force a HDMI mode rather than DVI. This can make audio work in# DMT (computer monitor) modes#hdmi_drive=2# uncomment to increase signal to HDMI, if you have interference, blanking, or# no display#config_hdmi_boost=4# uncomment for composite PAL#sdtv_mode=2#uncomment to overclock the arm. 700 MHz is the default.#arm_freq=800# Uncomment some or all of these to enable the optional hardware interfacesdtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Uncomment this to enable infrared communication.#dtoverlay=gpio-ir,gpio_pin=17#dtoverlay=gpio-ir-tx,gpio_pin=18# Additional overlays and parameters are documented /boot/overlays/README# Enable audio (loads snd_bcm2835)dtparam=audio=on[pi4]# Enable DRM VC4 V3D driver on top of the dispmanx display stackdtoverlay=vc4-fkms-v3dmax_framebuffers=2[all]dtoverlay=vc4-fkms-v3ddtoverlay=dwc2,dr_mode=hoststart_x=1gpu_mem=128dtparam=i2c_vc=onenable_uart=1dtoverlay=uartxdtoverlay=uart0dtoverlay=uart1dtoverlay=uart2dtoverlay=uart3dtoverlay=uart4dtoverlay=uart5dtoverlay=spi1-1csdtoverlay=disable-ctStatistics: Posted by wkh8913 — Wed Feb 28, 2024 5:11 am