Thanks for the clarifications.
So the wiring goes likes this :
Both XTR cables are soldered on the pads of each camera, and then soldered together, then plugged to the pulse source, in a T manner (xtr0 T xtr1, bottom of the vertical line of the T being the connection to the pulse source.)
Same goes for the GND cables.
And then both cables are connected as the doc requires, with the required resistors (connection to the pico). https://www.raspberrypi.com/documentati ... reparation.
Should they be plugged like that ?
Hope this helps.
So the wiring goes likes this :
Both XTR cables are soldered on the pads of each camera, and then soldered together, then plugged to the pulse source, in a T manner (xtr0 T xtr1, bottom of the vertical line of the T being the connection to the pulse source.)
Same goes for the GND cables.
And then both cables are connected as the doc requires, with the required resistors (connection to the pico). https://www.raspberrypi.com/documentati ... reparation.
Should they be plugged like that ?
Hope this helps.
Statistics: Posted by ricaizen — Mon Dec 15, 2025 4:12 pm