Hello all,
I'm building a CM4 powered low power NAS using the Raspberri PI Compute Module 4 IO Board.
I'm currently powering the board with a Pico PSU with +12v from the PSU going to the J19 Barrel Connector and powering a couple drives with the PSU's SATA power connectors.
I'd like to make a nice case to enclose everything and power the IO Board and CM4 from the J20 connector.
I read in the datasheet that in order to do that L5 should be removed – how do I go about doing that?
Does in need to be desoldered, or can it be removed with pliers some how?
Any tips on safely removing L5?
Thanks!
PhillFox
I'm building a CM4 powered low power NAS using the Raspberri PI Compute Module 4 IO Board.
I'm currently powering the board with a Pico PSU with +12v from the PSU going to the J19 Barrel Connector and powering a couple drives with the PSU's SATA power connectors.
I'd like to make a nice case to enclose everything and power the IO Board and CM4 from the J20 connector.
I read in the datasheet that in order to do that L5 should be removed – how do I go about doing that?
Does in need to be desoldered, or can it be removed with pliers some how?
Any tips on safely removing L5?
Thanks!
PhillFox
Statistics: Posted by PhillFox — Sun Jan 28, 2024 12:30 am