I recently got a Pi 4b with an case and case fan (all from Raspberry Pi).
I'm finding that the board is badly seated in the case. Inside the case there are 4 feet. The two on the left (power hdmi and jack side) look like they are just supposed to support the card. The two on the right look like they are supposed to engage the holes. The front one does so nicely. But the rear right one doesn't. As a consequence when the case is closed the front of the card is too high and it is very difficult to insert a microSD card.
Is this a common problem? I guess the fix is to try to shave a little off the rear right pin?
I'm finding that the board is badly seated in the case. Inside the case there are 4 feet. The two on the left (power hdmi and jack side) look like they are just supposed to support the card. The two on the right look like they are supposed to engage the holes. The front one does so nicely. But the rear right one doesn't. As a consequence when the case is closed the front of the card is too high and it is very difficult to insert a microSD card.
Is this a common problem? I guess the fix is to try to shave a little off the rear right pin?
Statistics: Posted by paulfvgpi — Sun Jul 20, 2025 9:52 am